لامپ خشککن آب دئیونایزه شده

Fri, 19 Jun 2026 02:18:05 +0800

در سطح سنگی، حتی وجود یک قطره آب نیز می‌تواند باعث خراب شدن کل محصول شود. باید از آب بی‌یون برای تمیز کردن استفاده کرد؛ اگر رطوبت به طور کامل از سطح پاک نشود، این امر منجر به آلودگی می‌شود و در نتیجه چسبندگی فوتورزیست نیز از بین می‌رود. روش‌های معمول خشک کردن، گرادیان‌های حرارتی در سطح ویفر ایجاد می‌کنند؛ این امر می‌تواند باعث اختلال در فرآیندهای پختن فوتورزیست شود. همچنین، اگر هیترها پایدار نباشند، ذراتی که تولید می‌شوند می‌توانند میزان ذرات موجود در اتاق‌های پاک را از حد مجاز فراتر ببرند.

هیتر سیستم خشککن ویفر صنعتی

Wed, 10 Jun 2026 01:49:39 +0800

On the fab floor, the wafer comes out of the final rinse — and that’s when the clock starts. Linger too long on the wet side and you’ll watch patterns collapse. Let the bake step drift even a degree, and you’re planting photoresist defects that won’t show up until electrical test. The drying heater isn’t a “nice-to-have.” It’s a real process control point. What actually matters under the hood We build these drying heaters around one number: thermal uniformity of ±0.1°C across the wafer plane. We get there with a short-wave infrared (IR) emitter layout and closed-loop control on every zone — so the setpoint is the measured temperature, not some inferred proxy. Chamber materials are chosen for low outgassing, and the airflow path is laid out to avoid shedding particles. In cleanroom Class 1–100, the system keeps particle generation low enough to protect the lithography stack. That translates into repeatable soft bake and hard bake, with temperature stability that keeps critical dimension (CD) and sidewall angle in spec. Why this matters in photoresist processing Photoresist is unforgiving. Not enough energy, and the film stays under-dried. Too much, and the photoresist flows or loses sensitivity. Our drying heater delivers stable, uniform heat with tight thermal budget control, so you cut down on rework and scrap. It’s built for 24/7 operation — maintenance on a schedule, not crisis management. And because it ramps fast to setpoint with low standby losses, energy use comes down. For you, that means fewer excursions, higher first-pass yield, and cycle time that behaves itself. The practical stuff you’ll want to plan for Installation means matching the tool interface and exhaust ducting to the platform you already have. On retrofits, the heater footprint may need minor tweaks. The quartz window and emitter array don’t like mechanical shock, so preventive maintenance has to follow the handling procedure. Plan a short qualification run after install. Use it to confirm uniformity maps and particle performance against your baseline before you trust it in production.

خشککردن on Indoor Warm IR Solutions

لامپ خشککن آب دئیونایزه شده

هیتر سیستم خشککن ویفر صنعتی